Gravel & Stone Calculators

3/4″ Crushed Stone Calculator

Tons, cubic yards, bags and truckloads of 3/4 inch crushed stone – clean or minus – for driveways, drainage beds, slab bases and paths.

  • Clean or 3/4″ minus
  • Tons, yards & bags
  • Free, no sign-up
3/4" Crushed Stone Calculator
Density: lb/ft³
%
“3/4 inch” can mean clean stone (no fines, drains, does not compact) or 3/4" minus (with fines, compacts into a hard base). Pick the right one – minus needs 15–20% extra for compaction.
stonegravelcalculator.com
Material estimate · weigh ticket
Material–
Area0 sq ft
Depth–
0tons
0 cubic yards
Volume0
Weight0
Bags0 ×
Truckloads0 ×
Est. cost–
Add a price for a cost estimate
How this was calculated
Estimate only. Densities are typical loose values – confirm with your supplier.
On this page

    3/4 inch crushed stone is the workhorse size of the quarry: big enough to drain and stay put, small enough to rake and walk on. It comes in two very different products. 3/4″ clean (also sold as #57, #67 or “washed 3/4”) has the fines screened out, drains freely and does not compact. 3/4″ minus (crusher run, #411, road base, DGA, 2A) still has the stone dust in it, so it packs into a hard, almost paved surface. This calculator handles both, with the right density and the right allowance – 5% waste for clean stone, 15–20% compaction for minus.

    How to use the 3/4″ crushed stone calculator

    1. Measure the area

      Length × width in feet, or the diameter for a round pad. Add extra rectangles for a parking spur, a path or a second bed.

    2. Choose a depth

      2″ for a decorative top-up, 3″ for a path or driveway top course, 4″ under a slab or patio, 6″ for a load-bearing base on soft ground.

    3. Clean or minus?

      Pick 3/4″ clean for drainage, driveway top courses and under slabs where you want water to pass. Pick 3/4″ minus for anything you will compact into a hard base – then raise the allowance to 15–20%.

    4. Read tons, yards and bags

      Quarries sell by the ton; some landscape yards sell by the cubic yard. Both are shown, plus 0.5 cu ft bags for small jobs and truckloads for big ones. Add a price for the cost.

    3/4″ crushed stone formula

    Cubic yards = Length (ft) × Width (ft) × Depth (in) ÷ 324
    Tons (clean) = cubic yards × 1.42  ·  Tons (3/4" minus) = cubic yards × 1.55

    Example: 20 × 12 ft shed pad, 4 inches of 3/4″ clean stone

    1. Area = 20 × 12 = 240 sq ft
    2. Volume = 240 × 4 ÷ 324 = 2.96 cubic yards
    3. Weight = 2.96 × 1.42 = 4.2 tons
    4. Add 5% waste → order 4.4 tons (about 3.1 yards)

    Using 3/4″ minus instead, compacted: 2.96 yd³ × 1.55 = 4.6 tons, plus 20% compaction = 5.5 tons.

    How much 3/4 inch gravel do I need? Quick reference

    Area2″ deep3″ deep4″ deep6″ deep
    10 × 10 (100 sq ft)0.62 yd³ · 0.9 t0.93 yd³ · 1.3 t1.23 yd³ · 1.75 t1.85 yd³ · 2.6 t
    12 × 12 (144 sq ft)0.89 yd³ · 1.3 t1.33 yd³ · 1.9 t1.78 yd³ · 2.5 t2.67 yd³ · 3.8 t
    20 × 12 (240 sq ft)1.48 yd³ · 2.1 t2.22 yd³ · 3.15 t2.96 yd³ · 4.2 t4.44 yd³ · 6.3 t
    20 × 20 (400 sq ft)2.47 yd³ · 3.5 t3.70 yd³ · 5.25 t4.94 yd³ · 7.0 t7.41 yd³ · 10.5 t
    50 × 12 (600 sq ft)3.70 yd³ · 5.25 t5.56 yd³ · 7.9 t7.41 yd³ · 10.5 t11.11 yd³ · 15.75 t

    3/4″ clean crushed stone at 105 lb/ft³ (1.42 tons per yard). For 3/4″ minus multiply tons by 1.1 and add 20% for compaction.

    Coverage per ton

    A ton of 3/4″ clean stone covers about 114 sq ft at 2″, 76 sq ft at 3″ and 57 sq ft at 4″. Because 3/4″ minus is denser and compacts, a ton of it covers about 15% less once it is rolled.

    MaterialDensityTons per yd³sq ft per ton at 2"sq ft per ton at 3"sq ft per ton at 4"sq ft per ton at 6"
    3/4" clean crushed stone105 lb/ft³1.42114765738
    3/4" minus (with fines, compacts)115 lb/ft³1.55104705235
    3/4" crushed granite110 lb/ft³1.49109735536
    3/4" crushed limestone100 lb/ft³1.35120806040
    3/4" bluestone / trap rock110 lb/ft³1.49109735536
    3/4" recycled concrete95 lb/ft³1.28126846342

    Coverage = 2,000 lb ÷ (density × depth in feet). Figures are for loose material; add 5–10% for waste and up to 20% for compacted base layers.

    3/4″ clean vs 3/4″ minus

    3/4″ clean (#57 / #67)3/4″ minus (crusher run / #411)
    FinesNone – washed or screenedStone dust included
    DrainageExcellentPoor – sheds water
    CompactsNo (locks slightly)Yes – 15–20% loss, sets hard
    Weight≈1.4 tons / yd³≈1.55 tons / yd³ loose, 1.8+ compacted
    Best forFrench drains, slab base, driveway top, pipe beddingPaver base, driveway base, shed pads, road base
    Allowance5%15–20%
    Typical price$30–$60 / ton$25–$45 / ton

    How much does 3/4 crushed stone weigh?

    Loose 3/4″ clean crushed limestone weighs about 105 lb per cubic foot – 2,835 lb or 1.42 tons per cubic yard. Granite and trap rock are around 110 lb/ft³ (1.5 tons per yard), recycled concrete about 95 lb/ft³ (1.3 tons), and 3/4″ minus with fines 115–125 lb/ft³ (1.55–1.7 tons). A 0.5 cu ft bag of 3/4″ stone weighs about 50 lb, so there are roughly 40 bags in a ton and 54 bags in a cubic yard.

    Common uses and depths

    • Driveway surface – 3–4″ of clean 3/4″ over a compacted base (see the gravel driveway calculator for the full three-layer build).
    • Under a concrete slab, shed or hot tub – 4″ of clean 3/4″ for drainage, or 4–6″ of 3/4″ minus compacted where you need a hard, level pad.
    • Paver base – 4–6″ of 3/4″ minus compacted in 2″ lifts; use the paver base calculator for base plus bedding sand.
    • French drains and foundation drains – clean 3/4″ only; fines clog the drain.
    • Paths and dog runs – 2–3″ of clean 3/4″; it is sharper underfoot than pea gravel but stays in place far better.

    3/4 inch gravel cost

    Expect $30–$60 per ton ($40–$85 per cubic yard) for 3/4″ clean crushed limestone at the quarry, $25–$45 per ton for 3/4″ minus, and $35–$75 per ton for granite or trap rock. Delivery runs $75–$150 for a full tri-axle (18–22 tons) and is often free above a minimum order. Bagged 3/4″ stone is $4–$7 per 0.5 cu ft bag – roughly four times the bulk price per ton.

    Frequently asked questions

    How many tons of 3/4 crushed stone are in a cubic yard?

    About 1.4 tons for clean 3/4″ stone (2,800–2,900 lb) and about 1.55 tons for 3/4″ minus with fines. One ton of clean stone is roughly 0.7 cubic yards.

    How much area will a ton of 3/4 gravel cover?

    At 3 inches deep a ton covers about 76 square feet; at 2 inches 114 sq ft; at 4 inches 57 sq ft.

    Is 3/4 crushed stone the same as #57?

    Nearly. #57 is a graded product from 1″ down to 1/2″ with no fines, and is what most quarries hand you if you ask for “3/4 clean”. #67 is slightly smaller. Both are 3/4″ clean stone for calculation purposes.

    Should I use 3/4 clean or 3/4 minus for a driveway?

    Both, in layers: minus (crusher run) as the compacted base and 3″ of clean 3/4″ on top for drainage and a loose, self-healing surface. If you want a hard, dust-free, almost paved surface, use minus alone and compact it – but it will shed water to the sides rather than soaking it in.

    How many bags of 3/4 inch gravel make a cubic yard?

    54 bags of 0.5 cu ft, or about 40 bags per ton. For anything over half a yard, bulk delivery is usually cheaper.

    How deep should 3/4 crushed stone be under a slab?

    A 4-inch layer of clean 3/4″ stone is standard under residential slabs – it gives a capillary break and a level, drained base. On soft or clay soil, go to 6″ or use a compacted minus base beneath the clean stone.

    Written by the Stone & Gravel Team

    We build free calculators for landscaping and construction materials. Every density and formula on this site is listed on our methodology page. Last updated October 6, 2026.